Mallet locomotive
From Wikipedia, the free encyclopedia
The Mallet Locomotive is a type of articulated locomotive, invented by a Swiss engineer named Anatole Mallet (and thus, the name is properly pronounced in the French manner, "Mallay").
In the Mallet locomotive, there are two powered trucks. The rear is rigidly attached to the main body and boiler of the locomotive, while the front powered truck is attached to the rear by a hinge, so that it may swing from side to side. The front end of the boiler rests upon a sliding bearing on the swinging front truck.
Contents |
[edit] Compound expansion
Mallet's original design was a compound locomotive, in which the steam is used twice, first in a set of high-pressure cylinders, and then in a set of low-pressure cylinders. This confers certain thermodynamic advantages, and also worked well with the Mallet design. Steam was fed from the steam dome down to the aft, high-pressure cylinders - the exhaust steam from those being fed forwards in a pipe with a swiveling joint - to the forward, low-pressure cylinders. The exhaust steam from the larger low-pressure cylinders is exhausted through a slit in the sliding bearing in the top of the swiveling truck and thus to the smokebox above, and the blastpipe (US: exhaust nozzle) and chimney (US: stack).
Unlike the case of the rigidly-framed locomotive, the Mallet design is easier to build as a compound, since steam and exhaust pipes are needed for both pairs of cylinders when it is built as a simple. When built as a compound, the only flexible steam pipes that are needed are the ones that deliver low-pressure steam from the rear cylinders to the front.
[edit] Simple expansion
Mallet's original patent specifies compound expansion. However many locomotives, particularly in the United States were built to Mallet's basic design but without employing compounding (for instance the Union Pacific Big Boy. The term "Mallet" is generally applied to all locomotives built to the basic wheel arrangement specified in the patent. Purists consider only compound locomotives to be true Mallets (example).
[edit] Size
Mallet's original design was intended to allow a medium-size locomotive to better negotiate the tight curves of a narrow gauge railway, but the Mallet design grew to enormous size in the United States, where it was used to permit locomotives to be built to sizes impossible with a single, rigid frame. The 4-8-8-4 "Big Boy" type used by Union Pacific Railroad or the 2-6-6-6 Allegheny of the Chesapeake and Ohio are generally regarded as the largest steam locomotives in the world. However outside North America, the Mallet type had generally been superseded by the Garratt locomotive by the mid 1920s.
