Downforce
From Wikipedia, the free encyclopedia
Three different styles of front the wings from three different Formula 1 eras, all designed to produce the downforce at and on the front wheels.
The term downforce describes the downward pressure created by the aerodynamic characteristics of a car that allows it to travel faster through a corner by holding the car to the track or road surface.
Contents |
[edit] Fundamentle principals
The same principle that allows an airplane to rise off the ground by creating lift under its wings is used in reverse to apply force that presses the race car against the surface of the track. This effect is referred to as "aerodynamic grip" and is distinguished from "mechanical grip," which is a function of the car mass repartition, tires and suspension. The creation of downforce by passive devices can only be achieved at the cost of increased aerodynamic drag (or friction), and the optimum setup is always a compromise between the two. The aerodynamic setup for a car can vary considerably between race tracks, depending on the length of the straights and the types of corners; some drivers also make different choices on setup. Because it is a function of the flow of air over and under the car, and because aerodynamic forces increase with the square of velocity, downforce increases with the square of the car's speed and requires a certain minimum speed in order to produce a significant effect. But some cars have had rather unstable aerodynamics, such that a minor change in angle of attack or height of the vehicle (for example, caused by a bump on the track or slipstreaming over a crest) has caused the car to experience lift, not downforce, sometimes with disastrous consequences. A notorious example of this was Mark Webber's Mercedes-Benz CLR in the 1999 Le Mans 24 hours, which flipped spectacularly after closely following a competitor car over a hump.
Two primary components of a racing car can be used to create downforce when the car is travelling at racing speed:
- the shape of the body, and
- the use of airfoils.
Most racing formulae have a ban on aerodynamic devices that can be adjusted during a race, except at pit stops.
The formula for downforce is given by:
Where:
- D is downforce in newtons
- WS is wingspan in metres
- H is height in metres
- AoA is angle of attack
- F is drag coefficient
- ρ is air density in kg/m³
- V is velocity in m/s
[edit] The body
The rounded and tapered shape of the top of the car is designed to slice through the air and minimize wind resistance. Detailed pieces of bodywork on top of the car can be added to allow a smooth flow of air to reach the downforce-creating elements (i.e., wings or spoilers, and underbody tunnels). The underside of the body is similar in shape to an inverted wing and creates an area of low pressure between the car and the track, pressing the car to the road. This is sometimes called a ground effect and has been the subject of many rule changes over the years in different racing series.
[edit] Airfoils
The amount of downforce created by the wings or spoilers on a car is dependent primarily on two things:
- The shape, including surface area, aspect ratio and cross-section of the device, and
- The device's orientation (or angle of attack).
A larger surface area creates greater downforce and greater drag. The aspect ratio is the width of the airfoil divided by its depth. Also, a greater angle of attack (or tilt) of the wing or spoiler, creates more downforce and more drag.
The rear wing of a 1998 Formula One car, with three aerodynamic elements (1, 2, 3). The rows of holes for adjustment of the angle of attack (4) and installation of another element (5) are visible on the wing's endplate.
[edit] Front
The function of the airfoils at the front of the car is twofold. They create downforce that enhances the grip of the front tires, while also optimizing (or minimizing disturbance to) the flow of air to the rest of the car. The front wings on an open-wheeled car undergo constant modification as data is gathered from race to race, and are customized for every characteristic of a particular circuit (see top photos). In most series, the wings are even designed for adjustment during the race itself when the car is serviced.
[edit] Rear
The flow of air at the rear of the car is affected by the front wings, front wheels, mirrors, driver's helmet, side pods and exhaust. This causes the rear wing to be less aerodynamically efficient than the front wing, Yet, because it must generate more than twice as much downforce as the front wings in order to maintain the handling to balance the car, the rear wing typically has a much larger aspect ratio, and often uses two or more elements to compound the amount of downforce created (see photo at left). Like the front wings, each of these elements can often be adjusted when the car is serviced, before or even during a race, and are the object of constant attention and modification
[edit] Wings in unusual places
Partly as a consequence of rules aimed at reducing downforce from the front and rear wings of F1 cars, several teams have sought to find other places to position wings. Small wings mounted on the rear of the cars' sidepods began to appear in mid-1994, and are now virtually standard on all F1 cars in one form or another. Other wings have sprung up in various other places about the car, but these modifications are usually only used at circuits where downforce is most sought, particularly the twisty Hungary and Monaco racetracks.
The 1995 McLaren Mercedes MP4/10 was one of the first cars to feature a "midwing", using a loophole in the regulations to mount a wing on top of the engine cover. This arrangement has since been used by every team on the grid at one time or another, and in the recent Monaco Grand Prix all but two teams used them. These midwings are not to be confused either with the roll-hoop mounted cameras which each car carries as standard in all races, or with the bull-horn shaped flow controllers first used by McLaren and since by BMW Sauber, whose primary function is to smooth and redirect the airflow in order to make the rear wing more effective rather than to generate downforce themselves.
A variation on this theme was "X-wings", high wings mounted on the front of the sidepods which used a similar loophole to midwings. These were first used by Tyrrell in 1997, and were last used in the 1998 San Marino Grand Prix, by which time Ferrari, Sauber, Jordan and others had used such an arrangement. However it was decided they would have to be banned in view of the obstruction they caused during refueling and the risk they posed to the driver should a car roll over. (It is rumored the Bernie Ecclestone saw them as being too ugly on television and therefore had them banned)
Various other extra wings have been tried from time to time, but nowadays it is more common for teams to seek to improve the performance of the front and rear wings by the use of various flow controllers such as the afore-mentioned "bull-horns" used by McLaren.
[edit] See also
[edit] External links
[edit] Book
Competition Car Downforce: A Practical Handbook by Simon McBeath (2nd edition), SAE International 2000 ISBN 1-85960-662-8
