Direct coupled
From Wikipedia, the free encyclopedia
Direct coupled, also known as "DC amp", refers to a type of amplifier. In this type of amplifier, the output of one stage of the amplifier is connected to the input of the next stage directly without using any reactive components like capacitors, inductors, transformers, and others. As a result, the frequency response of this amplifier is quite flat all the way down to DC (0 Hz).
Contents |
[edit] Current
The common use of the term "DC Amp" does not mean "direct current amplifier", as this type can be used for both D/C and A/C signals. The amplification of D/C (zero frequency) is possible only by this amplifier, hence it later becomes the building block for differential amplifier and operational amplifier. Unlike other multistage amplifiers, amplification of low frequency (below 10 Hz) signals is only possible using direct coupling. This is because use of coupling and bypass capacitors is not possible as they provide very high capacitive reactance.
[edit] Advantages
There are several advantages to using this type of amplifier, including:
- Simple circuit arrangement as there are minimum number of components
- For above reason, also quite inexpensive
- Can be used to amplify zero and low frequency signals
- Provides uniform frequency response up to a high frequency. Lower cut-off frequency is zero and upper cut-off frequency is determined by values of components used.
[edit] Disadvantages
In addition to the advantages, there are also several known disadvantages. These include:
- Unwanted change in output voltage without any change in the input is often observed. This is caused by temperature variations, aging of components, etc and is referred to as 'drift'. This drawback can be removed using differential amplifier.
- At high frequencies gain decreases
- Transistor parameters change with temperature, hence output is affected by temperature variations
- Even if input is A/C, some D/C component is present at output. This can be removed using differential amplifier
- Any noise or stray pickup appearing at the input is also present at the output in amplified form, due to high gain
[edit] Application
Direct coupled is used in TV receivers, computers, regulator circuits and other electronic instruments. It also forms a building block for differential amplifiers and operational amplifiers.
