Machinist square
From Wikipedia, the free encyclopedia
A machinist square or engineer's square is the metalworkers' equivalent of a try square. It consists of a steel blade inserted and either welded or pinned into a heavier body at an angle of 90°. In the accompanying image, there is evidence of pinning at the intersection of the blade and body, where the heads of two pins are visible as dark circles.
In use the body is aligned against the one edge of the object and the blade is presented to the end or body of the object. If the end is being checked, then a strong light source behind the square will show any mismatch between the blade of the square and the end of the object. The purpose of this action is to either check for squareness or to mark out the body of the workpiece.
Squares must be occasionally checked for accuracy. The four disk method is one way to do this.
[edit] References
 |
This article does not cite any references or sources. (February 2007) Please help improve this article by adding citations to reliable sources. Unverifiable material may be challenged and removed. |
|
||||||||
|
||||||||
