Lock picking

From Wikipedia, the free encyclopedia

Lock picking is the act of unlocking a lock by analysing and manipulating the components of the lock device, without the original key. Although lock picking can be associated with criminal intent, it is an essential skill for a locksmith. Lock picking is the ideal way of opening a lock without the correct key, while not damaging the lock, allowing it to be rekeyed for later use, which is especially important with antique locks that would be impossible to replace if destructive entry methods are used.

Usually it is possible to bypass a lock without picking it. Most common locks can be quickly and easily opened using a drill, bolt cutters, bump key, or a hydraulic jack. The hasp, door, or fixture they are attached to can be cut, broken, or otherwise removed.

A lock that offers high resistance to picking does not necessarily make unauthorized access more difficult, but it will make surreptitious unauthorized access more difficult. They are often used in combination with alarms to provide layered security.

Some people enjoy picking locks recreationally, because they find it brings high satisfaction and is an enjoyable way to pass the time; it also has hack value.

Contents 1 Key impressioning 1.1 Method 2 Tool sets 2.1 Torsion wrench 2.2 Hook pick 2.3 Warded pick 3 Legal status 3.1 United States 3.2 European Union 3.2.1 Netherlands 3.2.2 Poland 3.2.3 United Kingdom 3.3 New Zealand 4 See also 5 References 6 External links

Key impressioning

This section may stray from the topic of the article. Please help improve this section or discuss this issue on the talk page. (help)

Contrary to what one might think upon hearing the term, key impressioning does not have anything to do with molds. Instead, one starts with a key blank.

Method

This article or section contains instructions, advice, or how-to content. The purpose of Wikipedia is to present facts, not to teach subject matter. Please help improve this article by removing or rewriting the how-to content, which may qualify for a move to http://www.wikihow.com/ or http://howto.wikia.com/.

One uses the file to polish the top of the key; that is, the part of the key that the pins come into contact with. (Before starting the impressioning, it is good to count the number of pins in the lock with a hook pick, thus helping choose the correct sized blank.) The key is put into the keyhole and gently turned, binding the key, which is then jiggled up and down. This serves to leave perpendicular scrapes of the pins on the key.

After filing a few thousandths of brass off of the key with the pippen or rat tail file, the process is repeated. Care must be taken to only file if a little dimple is seen in the key grooves. When enough material has been filed from the blank, the blank will approximate the cut of the key and the lock should open when the key is turned.

This method makes high-security drivers (if they are grooved or mushroomed) irrelevant. This method works well on car doors and other wafer locks.

Tool sets

The tools for lock picking are usually different for each type of lock and can sometimes be improvised from common items.

Lock pick kits can be purchased openly via the Internet. Many different selections are present. Nine-piece sets and a 32-piece set equipped with a Pick Gun for example differ in value and price greatly. However, many lock pickers state that for most locking devices, a basic set of five picks is enough; therefore it is unnecessary to carry around a wide variety of professional lock picks.

Torsion wrench

The torsion wrench (also known as a tension or torque wrench), is used to apply torque to the lock plug to keep pins from being pushed back down by springs after they are correctly set at the shear line. It is usually anywhere from 1/16th inch to 1/8th inch wide, bent into an L, and occasionally has a quarter twist on the long side.

Hook pick

The hook pick is self explanatory, it is similar to the half diamond pick, but has a hook shaped tip rather than a half diamond shape. The hook pick is sometimes referred to as a 'feeler' and is generally used to lift the pins individually, rather than 'rake' them simultaneously.

Warded pick

A warded pick is a device for opening warded locks. It is generally made to conform to a generalized key shape relatively simpler than the actual key used to open the lock; this simpler shape allows for internal manipulations.

Legal status

United States

In the United States, laws concerning possession of lock picks vary from state to state. Generally, possession and use of lock picks is considered equivalent to the possession of a crowbar or any other tool that may or may not be used in a burglary. Illegal possession of lock picks is generally prosecuted as a felony under the category of possession of burglary tools or similar statutes. In many states, simple possession is completely legal as their statutes require proof of intent. In some states, however, possession without appropriate licensure is considered prima facie evidence of intent to commit a crime, rendering simple possession a crime.^[1]

In California, locksmiths must be licensed by the state.^[2] However simple possession is legal as illegal possession must be coupled with felonious or malicious intent.^[3]

In Utah possession itself is not a crime; intent to commit a crime is also required.^[4] Massachusetts, Maine, New Hampshire, and New York also require proof of intent, while mere possession is illegal in Washington, DC.^[5]

European Union

Most countries of the European Union don't regulate the possession of lock picks. All responsibility concerning criminal or legal acts using the picks is taken by the user of the lock picks, when the owner of the lock picks may be involved in the jurisdiction or legal process as an accomplice or witness.

Netherlands

In the Netherlands, owning lock picks is legal, but using them on someone else's locks without permission is not. There is a lock picking championship, the Dutch Open (organised by TOOOL), which was reported on in the newspapers.^[6]

Poland

In Poland according to the delinquency Codeep Act article 129 § 1:
1) possessing, producing or obtaining a lockpick by a person whose profession and occupation doesn't require it;
2) delivering a lockpick to a person whose profession and occupation doesn't require it;
3) […]
is punishable with arrest, freedom limitation or fine. § 3 says that that a lockpick is forfeited even if it wasn't a property of the principal.

United Kingdom

In the United Kingdom, a person who carries a lock pick set (even a home made one) can be charged with the offence of "going equipped", unless they have a good reason for carrying them.^[7] The penalty for this can be upward of 5 years' imprisonment. The arresting officer must have "reasonable cause".

New Zealand

In New Zealand lock picking tools are not illegal - but possession along with the intent to use them for burglary, carries a potential penalty of three years in prison. ^[8]

See also

• Hotwiring
• Lock bumping
• Physical Security
• Safe-cracking
• Security

References

External links

• Map detailing locksmith legislation in different states in the U.S. - Courtesy of ALOA.