Fission product yield

From Wikipedia, the free encyclopedia

The introduction to this article provides insufficient context for those unfamiliar with the subject. Please help improve the article with a good introductory style.

[edit] Mass vs. yield curve

From Fluoride volatility: Blue elements have volatile fluorides or are already volatile; green elements do not but have volatile chlorides; red elements have neither, but the elements themselves are volatile at very high temperatures. Yields at 10^0,1,2,3 years after fission, not considering later neutron capture, fraction of 100% not 200%. Beta decay Kr-85→Rb, Sr-90→Zr, Ru-106→Pd, Sb-125→Te, Cs-137→Ba, Ce-144→Nd, Sm-151→Eu, Eu-155→Gd visible.

Fission product yields by mass for thermal neutron fission of U-235, Pu-239, a combination of the two typical of current nuclear power reactors, and U-233 used in the thorium cycle

If a graph of the mass or mole yield of fission products against the atomic number of the fragments is drawn then it has two peaks, one in the area zirconium through to palladium and one at xenon through to neodymium. This is because the fission event causes the nucleus to split in an asymmetric manner.[1]

Yield vs. Z - This is a typical distribution for the fission of uranium. Note that in the calculations used to make this graph the activation of fission products was ignored and the fission was assumed to occur in a single moment rather than a length of time. In this bar chart results are shown for different cooling times (time after fission).

Because of the stability of nuclei with even numbers of protons and/or neutrons the curve of yield against element is not a smooth curve. It tends to alternate.

In general, the higher the energy of the state that undergoes nuclear fission, the more likely a symmetric fission is, hence as the neutron energy increases and/or the energy of the fissile atom increases, the valley between the two peaks becomes more shallow; for instance, the curve of yield against mass for Pu-239 has a more shallow valley than that observed for U-235, when the neutrons are thermal neutrons. The curves for the fission of the later actinides tend to make even more shallow valleys. In extreme cases such as ²⁵⁹Fm, only one peak is seen.

Yield is usually expressed relative to number of fissioning nuclei, not the number of fission product nuclei, that is, yields should sum to 200%.

The table in the next section gives yields for notable radioactive (with halflife greater than one year, plus iodine-131) fission products, and (the few most absorptive) neutron poison fission products, from thermal neutron fission of U-235 (typical of nuclear power reactors), computed from [2].

The yields in the table sum to only 45.5522%, including 34.8401% which have halflife greater than one year:

The remainder and the unlisted 154.4478% decay with halflife less than one year into nonradioactive nuclei.

This is before accounting for the effects of any subsequent neutron capture, e.g.:

• ¹³⁵Xe capturing a neutron and becoming nonradioactive ¹³⁶Xe, rather than decaying to ¹³⁵Cs which is radioactive with a halflife of 2.3 million years
• Nonradioactive ¹³³Cs capturing a neutron and becoming ¹³⁴Cs which is radioactive with a halflife of 2 years
• Many of the fission products with mass 147 or greater such as Promethium-147, Samarium-149, Samarium-151, Europium-155 have significant cross sections for neutron capture, so that one heavy fission product atom can undergo multiple successive neutron captures.

Besides fission products, the other types of radioactive products are

• plutonium containing ²³⁸Pu, ²³⁹Pu, ²⁴⁰Pu, ²⁴¹Pu, and ²⁴²Pu,
• minor actinides including ²³⁷Np, ²⁴¹Am, ²⁴³Am, curium isotopes, and perhaps californium
• reprocessed uranium containing ²³⁶U and other isotopes
• tritium
• activation products of neutron capture by the reactor or bomb structure or the environment

[edit] Ordered by yield (thermal neutron fission of U-235)

Yields at 10^0,1,2,3 years after fission, probably of Pu-239 not U-235 because left hump is shifted right, not considering later neutron capture, fraction of 100% not 200%. Beta decay Kr-85→Rb, Sr-90→Zr, Ru-106→Pd, Sb-125→Te, Cs-137→Ba, Ce-144→Nd, Sm-151→Eu, Eu-155→Gd visible.

[edit] Ordered by mass number

[edit] Ordered by halflife

[edit] Ordered by thermal neutron neutron absorption cross section

[edit] References

• Chain Fission Yields For 90-Th-232 92-U-233 92-U-235 92-U-238 94-Pu-239 94-Pu-241, and Thermal, Fast, 14MeV.